• On metal free copings, only single crowns, inlays and onlays can be done
• On metal supported copings, even longspan bridges can be done
• Indirect and direct repairs of crown restorations and defects in prosthetic restorations.

• Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.
• All repetitions and corrections should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.
• To claim warranty for DentCare prostheses, the patient should consult the same doctor or clinic, not the Lab directly Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any. Patient cannot claim warranty for any sort of prostheses upgradation.
• Products described without warranty in the price list will not have any warranty.
• By delivering DentCare prostheses to the patient the dentist approves and takes responsibility that all clinical requirements are fulfilled.
• Payment through at par cheque / DD should be made against delivery.
• Ensure giving temporary crown / bridge, after tooth preparation. We won't be responsible for problems in insertion, if temporary crown or bridge is not given.
• An order placed, cannot be withdrawn.
• We need 7 working days to complete a work excluding Second Saturdays, Sundays and other Holidays.
• Prices are inclusive of GST.
• Prices are subject to change without prior information.
• All legal disputes shall be within Muvattupuzha jurisdiction.

URGENT ORDERS

Urgent orders will be charged 10% extra. The fabrication time depends on prosthesis type and number of units. (For more details please refer time schedule)

SUGGESTIONS

• The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.
• "We always prefer perfect rubber base impression". Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.
• Don't allow the alginate impression to get dried. Pour Die Stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.), discard it, and take a new impression rather than trying to produce a second model from the old alginate impression. We need upper and lower full arch Die Stone type IV models to check the occlusion correctly.
• Provide bite registration in Silicone putty (not in wax), if necessary.
• The shade will be perfect only if the labial and occlusal clearance is 2mm and the shade should be taken in natural light.
• VITA classical or VITA 3D master or Ivoclar A-D shade number should be given for ceramic shade selection.
• Avoid grinding the metal prosthesis at the time of metal trial.
• This may lead to contamination of metal and ceramic chip- off. Always provide pre-operative model for anterior cases, if the patient is satisfied with the temporary crown/ bridge, kindly provide a model of that, which will help us in imitating the shape and arrangement.
• Pre-operative model will also be useful in some cases.